MITSUBISHI
Home >> Products >> MITSUBISHI >> Touch Screen >> Touch screen accessories >> GOT1000 touch screen accessories >> GT15-60PSCB Resist film

GT15-60PSCB Resist film

MITSUBISHI GT15-60PSCB Manual And Instructions
GT15-60PSCB datasheetPDF datasheet
GT15-60PSCB User's Manual

MITSUBISHI GT15-60PSCB Product information and technical parameters:
Brand: MITSUBISHI
Name: Resist film
Model: GT15-60PSCB
Protective film for 8.4 inch screen.
Transparent, 5.
Applicable model: GT15.

RS-232 to RS422 conversion unit (RS-422 connector: 25-pin).
Applicable models: GT15, GT16. Cable length: 1.2m.
For motion controller CPU (A series, the main base system) and the connection between GOT.
Applicable models: GT16, GT15, GT11. Series: multimedia and advanced features and features of a variety of high-performance models GT15-60PSCB.
Screen size: 15 inches.
Display color: 256 color or more color GT15-60PSCB
Installation type: compatible with multimedia and video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
High performance models with multimedia and advanced features and functionality (including embedded communications capabilities) GT15-60PSCB.
User storage capacity: 15MB (GT16__-VNB__:11MB).
With HOST USB and device USB port.
Standard Ethernet, RS-422/485 and RS-232 ports.
Support multimedia and video /RGB units.
Analog touch panel.
Do not let the touch screen surface with water drops or other soft things stick to the surface,
Otherwise, the touch screen is easy to mistake that there is a hand touch caused by surface acoustic wave screen is not allowed GT15-60PSCB.
In addition to cleaning the dirt on the surface of the touch screen,
You can use a soft dry cloth or a cleaning agent to clean out the center of the screen carefully,
Or use a dry soft cloth dipped in industrial alcohol or glass cleaning fluid to clean the touch screen surface.
Touch screen response is slow if you use a hand or other touch to touch the surface acoustic wave touch screen,
This shows that it is likely that the touch screen system has been obsolete, the internal clock frequency is too low,
Or because there is water in the surface of the touch screen to make the touch screen mobile, rapid response recovery,
To replace or upgrade the system mustt, or use dry cloth touch screen on the surface of the water GT15-60PSCB.
If the user is operating the touch screen, the direction of the touch move is to the left,
But the cursor of the system moves to the right,
The failure may be due to the conneection of the control box and the touch screen connected to the connector or the touch screen,
Users as long as the direction of the re exchange of it GT15-60PSCB.


...More relevant models >>>>