MITSUBISHI MITSUBISHI AJ71E71N-T Price

1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 0.4kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V or single phase AC200V power supply.
Single phase AC200V is limited to 0.75kW following servo amplifier.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system AJ71E71N-T
MELSERVO-J4 grand debut.
Servo market for the star of tomorrow. World class servo products.
The new generation of MELSERVO should be what kind of? The answer to this question is already floating
Out of the water. MELSERVO-J4, it represents the whole digital, the original high performance based on an evolutionary.
Is also fully meet the requirements of human beings and the environment MELSERVO latest masterpiece.
For example, the safety and environmental requirements for the safety of human use and the safety specifications and "to Use Easy" design.
To meet the needs of the environmental protection era of energy-saving performance.
Beyond the performance of the evolution of MELSERVO-J4, shocking debut!The length of the line: 2M.
IP level: IP65.
Direct type.
The cable is not shielded.
Bending life: standard.
Connector kit for motor electromagnetic brake.
Cable for electromagnetic brake, for HF-KP/HF-MP series (motor shaft with side extraction). Analog channel: 8 channels.
Input / output (resolution): 0 ~ 4000.
Conversion speed: 100ms/8 channel.
Analog module installation.
Power supply: AC85 ~ 132V.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
AJ71E71N-T Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=AJ71E71N-T&select=5