MITSUBISHI
Home >> Products >> MITSUBISHI >> Q series PLC >> Positioning module >> Corresponding SSCNET positioning module >> QD75M4 Corresponding SSCNET positioning module

QD75M4 Corresponding SSCNET positioning module

MITSUBISHI QD75M4 Manual And Instructions
QD75M4 datasheetPDF datasheet
QD75M4 HardwareUser's Manual
QD75M4 DetailsUser's Manual

MITSUBISHI QD75M4 Product information and technical parameters:
Brand: MITSUBISHI
Name: Corresponding SSCNET positioning module
Model: QD75M4
"4 axes, SSCNET connection type.
2 axis /4 axis /3 axis linear interpolation.
2 axis interpolation.
Control unit: mm, inch, degree, pulse.
Location data: 600 data / axis.
40 pin connector.
Easy to achieve high speed, high precision positioning control.
Support for multiple types of positioning control,
Including 2 ~ 4 axis 2 axis linear interpolation, circular interpolation, speed control and speed / position control, path switching control, constant speed control etc..
In addition, can use the "Configurator-QP GX" and other software,
Easy to set, monitor and debug.
Saving wiring through SSCNET cable connections while simultaneously,
The length of the total cable distance up to 30m.
In addition, an absolute position system for determining the origin position is supported by the return data set operation of the origin.
No need for the near point block, such as wiring. "

8 channels.
Input: AC0~5A AC0~50A, CT, AC0~100 until AC0~600A.
Output: 0~10000.
18 point terminal.
Directly connected to the CT sensor, saving wiring and space of the CT input module.
Directly connected with CT sensor and programmable controller,
No need for external connection signal converter, etc QD75M4. .
Very accurate measurement results can be obtained by stable data transfer speed,
Then, load control and operation of the system and equipment are carried out, and the power supply system is managed and monitored QD75M4
Directly connect the CT sensor, saving wiring and space
In the case of no external signal converter, directly connected to the CT sensor.
A module can be used to measure up to 8 channels of alternating current, thereby reducing wiring time and cost QD75M4.
Set the CT sensor type (input range) for each channel.
Through a module to select from AC0 ~ 5A to 600A ~ CT AC0 sensor.
Preventive maintenance can be carried out by detecting the peak current.
Peak current detection function
By detecting the peak current, the equipment can perform maintenance and troubleshooting.
Take the motor as an example, the load applied on the motor changes due to wear and damage of the gear,
Load current will suddenly change QD75M4.
By detecting the transient peak current at this time, the fault of the equipment can be diagnosed.
Input signal error detection function
Can detect whether the CT input value is out of range (higher than the peak value).
Because the large current flow on the measurement object is beyond the range limit,
Therefore, the error of the measurement object can be monitored. Axis of control: 16.
Compact Q170MCPU integrated power supply module, PLC and motion controller,
And built in the packaging equipment uused in the incremental synchronous encoder signal and signal detection signal required for the interface,
Do not need to add the appropriate module QD75M4.
Reduce the design cost of the system expansion!
Although the structure is compact, but as a motor controller based on the iQ platform of MITSUBISHI motor,
Q170MCPU as an independent motion controller, also has high performance and easy to use QD75M4.


...More relevant models >>>>